Oce CS9065 User Manual page 54

Step 3 :
Verify if the sheet lamp on the operation panel is unlit.
Step 4 :
Press the [F4] key on the operation panel to lower the pressure rollers.
The MEDIA SET lamp will light orange.
The following message is displayed on the operation panel :
Step 5 :
Open the front cover (1) as shown on the image below.
Caution :
•
Step 6 :
Load the sheet media (1) into the insertion slot (2) at the front of the printer.
→ Please Set Paper
Heaters
Cut&Feed
User1
Be careful not to pinch your fingers when opening and closing the front cover.
1 = Front cover
1 = Sheet media
2 = Insertion slot
Cleaning
Lever Up
xxxm
54
Chapter 4 : Preparing for a job
AP-75037, Rev. 1.1, 24/04/2006