Cut Size Menu; Top Feed Menu - Oce CS9065 User Manual

5.4.2.20 Cut size menu

When setting sheet media in the tray, set the method for detecting the size of the media.
Current parameter →
Setup items Parameters
Cut Size <Auto>
Length
Width
-
Notes :
•
•

5.4.2.21 Top feed menu

Sets the amount of media to be fed when printing begins. Make this setting when using roll media.
Setup items Parameters
Top feed <0mm>-400mm
* CutSize *
F1 → Auto
F3 → Width
- Length -
When using sheet media other than recommended media, set to "blank form
vertical" or "blank form horizontal".
The following size of sheet media can be set.
ISO series (A0, A1, A2, A3, A4)
o
JIS series (B1, B2, B3, B4)
o
ARCH series (A, B, C, D)
o
* TopFeed *
0 mm – 400 mm
F2, F4
Length
(1/1)
Description
The length and width of the sheet media is
automatically detected.
Make this setting when placing normal size sheet
media vertically on the tray.
Make this setting when placing normal size sheet
media horizontally on the tray.
After setting, shifts to the previous menu.
Refer to Media setup menu
+
0 mm -
→ ENTER
Description
To feed media at the start of printing. Set when
printing on roll media.
• "F2" key: Increases the setting value.
• "F4" key: Reduces the setting value.
• "ENTER" key: Sets the setting value, and moves
the screen to the previous menu.
• [CANCEL] key: Cancels the setup value and shifts
to the previous menu.
Refer to Media setup menu
102
Chapter 5 : Handling the printer
← F2
← F2
← F4
AP-75037, Rev. 1.1, 24/04/2006