PART 2 : Leveling the printer in X – direction (3 steps)
Step 1 :
Position the level on the print platform.
Step 2 :
Turn the left and right weight supports an equal amounts of turns. (See picture below)
Note :
•
3.4.3 Adjusting the weight supports of the UW/W 100
Note :
•
Make sure to turn the left and right weight supports an equal amount of turns,
otherwise the leveling in Y direction was useless.
Please refer to the User's Guide of the UW/W 100 to adjust the weight supports.
40
Chapter 3 : Setting up the unit
End of part 2 and the leveling procedure
AP-75037, Rev. 1.1, 24/04/2006