Oce CS9065 User Manual page 87

Step 3 :
Confirm printing result by referring to the following figure.
Step 4 :
When printing by distance adjustment has been finished, press the [CANCEL] key on the
operation panel.
The following messages are displayed on the operation panel.
•
Press the [F2] key on the operation panel.
The following messages are displayed on the operation panel.
Step 6 :
Press the [F2] or [F4] key on the operation panel to set the distance adjustment value based on
the printing result in Step 3.
Step 7 :
Press the [ENTER] key on the operation panel to confirm the setup value.
The operation panel shifts to the previous menu.
Step 8 :
Repeat step 2-7 until good printing result has been obtained.
Warning :
•
* Dist. Adj *
Print 1
Print 2
* Change *
90.00 % - 110.00 %
F2, F4
Some RIP software use USER 8 media type by default. In this case, changing
the step adjust value doesn't seem to have any effect. You can avoid this
problem by first selecting USER 8 and then changing the step adjust for
USER 8.
Change
(1/1)
+
110.00% -
→
ENTER
87
Chapter 5 : Handling the printer
← F2
End of the distance adjustment procedure
AP-75037, Rev. 1.1, 24/04/2006