Transporting The Printer - Oce CS9065 User Manual

(2) After the transfer
Follow the 4 steps below to prepare the printer to be used after the transfer.
Step 1 : Make sure that you place the printer on an adequate place.
Note :
• For connecting cables, refer to the following.
→ Connecting the printer to your PC
Step 2 : Connect the power cable and other cables.
Step 3 : Perform a nozzle check to check if the printer head has clogged.
Note :
•
Step 4 : Perform a fine adjustment of image quality.
Note :
•

7.5.2 Transporting the printer

When you transport the printer, the printer should be repacked in the original box and packing materials, to
protect it from vibration or impact.
The printer should be in long store conditions.
Notes :
•
→ Connecting the power cable
To perform the nozzle check, refer to 4.7.2 NozzleCheck (page 64)
To perform an adjustment of image quality, refer to 4.7.3 Alignment (page 65)
When you transport the printer, contact your local Océ representative for assistance.
196
Chapter 8 : Appendix
End of procedure
AP-75037, Rev. 1.1, 24/04/2006