Command Setup Menu - Oce CS9065 User Manual

5.4.3.10 Command setup menu

To perform various settings for printer commands.
Setup items Parameters
Command setup Command
(1/2)
Step
Position
Terminator
Command setup ImageResolu
(2/2)
OnlineTimer
Overwrite
Halftone
Command setup -
(1/2-2/2)
* Command *
F1 → Command
F3 → Position
* Command *
F1 → Resolu.
F3 → Overwrite
Step
Terminator
(1/2)
OnlineTimer
Halftone
(2/2)
Description
To make the settings for the conditions of printer
commands sent from the computer to the product.
Refer to Command select menu
To set the units for amount of movement for printing.
Refer to Print step menu
To set the initial writing position for printing.
Refer to Print position menu
To set the functions for when printing has been
completed for printer commands included in printing
data.
Refer to Terminator menu
Makes settings for image resolution while printing
with image data.
Refer to Image resolution menu
Makes settings for the time between the end of
receiving printing data from a computer and
recognizing the end of printing data.
Refer to Online time out menu
Sets the printing method for areas where figures
overlap on the printing data.
Refer to Overwrite menu
When creating prints of MH-GL/GL2 (vector) data
and RTLPASS (raster) data that have not been
converted into binary, set the gradation sequence
representation method.
Refer to Halftone menu
[CANCEL] key: to shift to the previous menu.
Refer to Setup menu
108
Chapter 5 : Handling the printer
← F2
← F4
← F2
← F4
AP-75037, Rev. 1.1, 24/04/2006