Replacing The Waste Liquid Tank - Oce CS9065 User Manual

7.2.6 Replacing the waste liquid tank

Read following information on when and how to replace the waste liquid tank.
(1) Replacement Time
Replace the waste liquid tank under the following conditions.
a. When the waste liquid tank is nearly full.
•
Following message is displayed on the operation panel.
•
Printing continues.
•
Prepare a new waste liquid tank before the waste liquid tank becomes full.
Press the [ENTER] key in the active display (=WiperClean menu)
The head will cap in and be locked.
(2) Replacement Procedures
Follow the steps below to replace the waste liquid tank.
Step 1 : Check the following if the power of the printer is ON.
Printer is not printing.
Operation panel is in normal status.
Media setting light on the operation panel is off.
Step 2 : Follow "Menu setup on the operation panel" and display the tank replacement menu on the
operation panel. (Refer to 'Tank change menu')
Step 3 : Open the cap of the waste liquid tank.
Caution :
•
Warning Waste InkTank
F1 Heaters
F3 Cut&Feed
User1
*TankChg.*
F1 No
F3
Changed waste
Ink tank ?
ENTER or
Do not bend or pull the waste fluid tube. Doing so may cause that the waste fluid
will leak out and malfunction in the product.
Cleaning
LeverUp
0m
Yes
(1/1)
CANCEL
188
Chapter 7 : Maintenance
F2
F4
F2
F4
AP-75037, Rev. 1.1, 24/04/2006