Nightly Shutdown; Figure 2-4. Cleaning The Capping Station - Oce Arizona 30 Maintenance Manual

Arizona 30 Maintenance Guide
8. Press F1, then ENTER to perform a soft clean.
9. Print a prime test.
If necessary, and depending on the results of the prime test, perform a soft clean, pressure prime
or hard clean (refer to Arizona 30 Sign Printer User Guide for more details). Repeat Steps 9 and
10 until print quality is acceptable.

Nightly Shutdown

This procedure should also be performed if the printer will be powered off for more than 10
minutes.
1. Top up the ink tanks.
2. Press ENTER for 10 seconds to clear any liquid from the caps.
3. Power down the printer.
4. Manually move the print head carriage out of the maintenance station.
5. Clean the outside of each cap with a swab soaked in CGS 80 (Figure 2-4).
6. Set the RUN/CLEAN switch (Figure 2-2) to CLEAN.
7. Fill a solvent syringe with about 30 cc of CGS 80 and connect the syringe to the solvent
injection port (Figure 2-2).
8. Holding the syringe upright so air doesn't get into the tube, quickly inject solvent until the
maintenance station caps are brimming with solvent.
2-4 see copyright, disclosure, use and duplication information on pg ii
×

Figure 2-4. Cleaning the capping station.

48210-A