Connecting The Foot Switch For The Pressure Roller - Oce CS9065 User Manual

4.3 CONNECTING THE FOOT SWITCH FOR THE PRESSURE
ROLLER
If the pressure roller needs to be raised or lowered, it is possible to control this motion from the foot switch,
instead of doing so at the operation panel.
Caution :
•
Install the foot switch according to following procedure :
Procedure (3 steps) :
Step 1 :
Make sure that the power of the unit is OFF.
Notes :
•
Step 2 :
Connect the foot switch cable connector to the foot switch connector at the rear of the unit and fix
into place.
Step 3 :
Place the foot switch on the floor under the stand.
When handling the foot switch, be aware of the following:
Do not place anything heavy on the foot switch.
o
Do not bend the cable of the foot switch with force and do not pull.
o
Do not place the foot switch near thermal devices.
o
When the operation panel is in the following condition, the power is ON. Press the
key again to turn the power OFF.
The POWER lamp is lit (green).
o
1 = Foot switch connector
2 = Foot switch cable
45
Chapter 4 : Preparing for a job
End of the installing the footswitch procedure
AP-75037, Rev. 1.1, 24/04/2006