Menu Setup On The Operation Panel - Oce CS9065 User Manual

5.4 MENU SETUP ON THE OPERATION PANEL

This section describes how to set the menu settings on the operation panel, and setup items.
Follow the 2 steps below to set the menu settings.
Step 1 :
Make sure that the operation panel is in normal mode.
Step 2 :
Press the [MENU ▲] or [MENU ▼] key.
•
The screen shows following menu :
Current Setup Menu →
Notes :
•
•
•
Each table shows the factory default settings.
1 → Ready to print
2 →
Heaters
4 →
Cut&Feed
6 → User1
* SetupMenu *
F1 → Ink Status
F3 →
TestPrint
For functions of the operation panel with the setup menu displayed, refer to the
following :
5.5 Operating from the operation panel (page 145)
o
5.4.1 Setup menu (page 89)
o
For the structure of the setup menu, refer to the following :
5.4.1.2 Setup menu structure (page 90)
o
When page numbers of the setup menu have been displayed on the operation
panel, you can change the sequence by pressing the [MENU↑] or [MENU↓] key.
Cleaning
Lever Up
xxxm
OriginSet
MediaSet
(1/7)
88
Chapter 5 : Handling the printer
← 3
← 5
← 7
← F2
← F4
End of the procedure
AP-75037, Rev. 1.1, 24/04/2006