Head Height Menu; Stiffness Menu - Oce CS9065 User Manual

5.4.2.9 Head Height menu

Sets the distance (head height) between the print head and the media.
Head height can be changed to three levels according to media thickness.
Current parameter →
Setup items Parameters
HeadHeight Low
Middle
High
-
Notes :
•

5.4.2.10 Stiffness menu

Sets the media sticking force (media stiffness) to the media guide.
Current parameter →
Setup items Parameters
Stiff <Normal>
Soft
-
* HeadHeight *
F1 → Low
F3 → High
- low -
Set the height of the head in relation to the thickness of the media.
If the setting is set to "High" and the print is created on thin media, good
o
quality print results will not be achieved.
If the setting is set to "Low" and thick media is used, the media and print
o
head will come into contact and may result in damage to the product.
* Stiff *
F1 → Soft
- Normal -
Middle
(1/1)
Description
Make this setting when using media with a thickness
of 80µm (0.08mm) to 300µm (0.3mm).
Make this setting when using media with a thickness
of 300µm (0.3mm) to 700µm (0.7mm).
Make this setting when using media with a thickness
of 700µm (0.7mm) to 1000µm (1.0mm).
Refer to User media menu
Normal
(1/1)
Description
Setting for normal media
Setting for soft media where media feeding errors
and media jams occur
After setting, shifts to the previous menu.
Refer to User media menu
97
Chapter 5 : Handling the printer
← F2
← F2
AP-75037, Rev. 1.1, 24/04/2006