3.4.2 Leveling the printer
PART 1 : Leveling the printer in Y – direction (3 steps)
Step 1 :
Position the printer in its final position.
Step 2 :
Turn down all feet of the printer stand (NOT those of the UW/W 100) with an equal pressure until
the wheels come off the ground. Use a forkspanner.
Step 3 :
Place the level on the left and right side of the printer's stand and level the printer sides by
turning the feet under the stand. The image below shows the Y – leveling direction.
1 = Foot
2 = Wheel
39
Chapter 3 : Setting up the unit
End of part 1
AP-75037, Rev. 1.1, 24/04/2006