Oce CS9065 User Manual page 59

Step 7 : Load media through the rear tensioning system as shown below.
Printable side on the outside of the roll
P 2 : L
ART OADING THE MEDIA TROUGH THE FRONT TENSIONING SYSTEM
Step 1 : Load the media through the printer's pressure rollers.
Step 2 : Standing in front of the printer, take the media and pull it until there is equal tension on the left
and right of the media.
•
Do not pull the media in the middle.
Step 3 : Lower the pressure rollers of the printer.
Step 4 : Set the unwinder (REAR) unit to AUTOMATIC.
•
The rear tensioning system will go to its initial position.
Step 5 : Close the front cover.
Step 6 : Start printing until the media reaches the front core of the winder OR feed the media without
printing.
Step 7 : Use tape to fix the media end to the empty core installed at the winder unit. Start taping the
middle of the media, then the both ends, applying equal tension on both ends.
Step 8 : Set the winder (FRONT) unit to ACTIVE. The front tensioning system will be activated.
1 = Unwinder
2 = Rear tensioning system
3 = Media insertion slot of the printer
59
Chapter 4 : Preparing for a job
Printable side on the inside of the roll
(P
ROCEDURE
End of the loading media into the printer procedures
AP-75037, Rev. 1.1, 24/04/2006
End of part 1
- 8 steps)