Feeding Media - Oce CS9065 User Manual

5.5.2 Feeding media

When you want to feed media forward or backward, follow the steps below :
Step 1 : Verify the following regarding the condition of the printer.
It is not currently printing
Step 2 : Press the [F3] key of the operation panel.
To shift to the Cut and Feed menu.
Step 3 : Press the [F3] key or the [F4] key on the operation panel.
The product will perform following operations:
Setup items
Cut & Feed
Notes :
•
Ready to print
Heaters
F3 → Cut&Feed
User1
* Cut&Feed *
Cut
F3 →
Forward
Key name
F3
F4
If "Take-Up Roll" is set in the media detection setup menu, the product will not
operate even if the [F4] key has been pressed.
Refer to 5.4.5.3 Media detection menu (page 121)
Cleaning
LeverUp
xxxm
Backward
Parameters
Forward
Backward
148
Chapter 5 : Handling the printer
← F4
Description
Feeds media forward.
Feeds media backward.
End of the feeding media procedure
AP-75037, Rev. 1.1, 24/04/2006