Operations After Printing; Automatically Cutting Media - Oce CS9065 User Manual

5.7 OPERATIONS AFTER PRINTING

The operations performed after printing, are described here.

5.7.1 Automatically cutting media

Roll media is automatically cut after printing when "Auto" is set on the cut media menu and roll media has
been set.
When the operation panel is in the normal status, and the product is in the following conditions, the media
can be cut on the desired position:
• When roll media has been set:
• If "OFF" is set on the cut media menu
• If "Take Up Roll" has been set in the media detection setup menu
• When sheet media has been set
Follow the 4 steps below to cut the media.
Step 1 : Make sure that the MEDIA SET lamp on the operation panel is off.
Step 2 : Press the [F3] key on the operation panel.
Shift to the cut and feed menu.
Step 3 : Feed media to the desired position according to the procedure in "Feeding media".
The procedure continues on next page.
Ready to print
Heaters
F3 → Cut&Feed
User1
* Cut&Feed *
Cut
F3 → Forward
* Cut&Feed *
F1 →
Cut
Forward
Cleaning
LeverUp
xxxm
Backward
Backward
155
Chapter 5 : Handling the printer
← F4
← F4
AP-75037, Rev. 1.1, 24/04/2006