4.8.4 Connecting the network interface
Caution :
•
The procedure for connecting the network interface is explained below.
To connect the printer to the network environment, follow the steps below.
Procedure (3 steps) :
Step 1 :
Turn off the printer.
Step 2 :
Plug the connector of the Ethernet cable into the connector of the network interface board at the
back of the printer.
Step 3 :
Connect the other end of the Ethernet cable to the network.
Follow the instructions below when connecting the network interface cable.
Otherwise, electrical shock or fire may occur.
Do not touch the connector.
o
Do not connect the network cable connector to the interface board having
o
different specifications.
1 = Network interface connector
2 = Interface cable
70
Chapter 4 : Preparing for a job
AP-75037, Rev. 1.1, 24/04/2006