Oce CS9065 User Manual page 55

Step 7 :
Set the right edge of the media (1) paralleled with the media loading position (2).
Notes :
•
•
Step 8 :
Press the [F4] key on the operation panel to lower the pressure rollers.
The MEDIA SET lamp will turn off.
Step 9 :
Close the front cover (1) as shown on the image below.
Notes :
•
Next step of the procedure on next page
1 = Sheet media
2 = Media loading position
The media set position is a guideline for setting up the media.
If the right edge of the sheet media is 5 mm or more from the media setting
position, a media set error may occur if the media has not been detected. Make
sure to set the right edge of the sheet media within 5 mm of the media setting
position.
Be careful not to pinch your fingers when opening and closing the front cover.
1 = Front cover
55
Chapter 4 : Preparing for a job
AP-75037, Rev. 1.1, 24/04/2006