Replacing The Cutting Blade; Replacement Time; Replacement Procedure - Oce CS9065 User Manual

7.2.5 Replacing the cutting blade

7.2.5.1 Replacement time

Replace the cutting blade under the following conditions.
a. Media cannot be cut cleanly
The message "media Cut Error" appears on the operation panel if a media cutting error occurs.
b. When the cut edge has scuffing

7.2.5.2 Replacement procedure

Follow the steps below to replace the cutting blade.
Step 1 : If the printer is turned on, make sure of the following
Printing or other operations are not performed.
Make sure that the display on the operation panel shows the normal status.
The MEDIA SET light on the operation panel goes off.
Step 2 : Follow "Menu setup on the operation panel" and display the cutting blade replacement menu on
the operation panel.(Refer to 'Cutter change menu')
Step 3 : Select "Yes" by pressing the [F2] key on the operation panel.
The printer prepares for cutting blade replacement.
The carriage moves to the cutting blade replacement position.
The following message is displayed on the operation panel.
Notes :
Step 4 : Open the front cover.
→ Paper Cut Error
Heaters
Cut&Feed
User1
* CutterChg. *
No
•
If you did one of the things mentioned in step 3, the printer does not replace the
cutting blade and returns to the setup menu.
•
Press the [CANCEL] key on the operation panel.
•
Select "NO" then press the [F1] key on the operation panel.
* CutterChg. *
Changed
Cleaning
LeverUp
xxxm
Yes
(1/1)
cutter?
→ ENTER
185
Chapter 7 : Maintenance
← F2
AP-75037, Rev. 1.1, 24/04/2006