Loading The Media Into The Printer - Oce CS9065 User Manual

Hide thumbs Also See for CS9065:
Table of Contents

Advertisement

Step 4 :
Lock one roll unit to the roll unit bar
Step 5 :
Place one side of the roll over the flange of the locked unit.
Step 6 :
Slide the flange of the other roll unit into the roll and lock the unit by using the its handle.
Step 7 :
You can now de-lock both sides to do adjustment of the position of the roll. The middle of the roll
has to correspond to the middle of the printing space. After adjustment, lock both roll units again.
Note :

4.6.3 Loading the media into the printer

This procedure contains 2 parts (Part 1 and Part2)
P
1 : I
ART
NSTALLING AN EMPTY CORE AND LOADING THE MEDIA THROUGH THE REAR TENSIONING
(P
SYSTEM
ROCEDURE
Step 1 :
Make sure the printer and UW/W 100 are ON.
Step 2 :
Press the [F4] key to raise the pressure rollers.
Step 3 :
Open the front cover.
Step 4 :
Install an empty core between the motorized roll unit and roll unit of the winder unit on front of the
printer.
Make sure the core is longer then the media width.
Note :
Step 5 :
Make sure both unwinder (REAR) and winder (FRONT) unit are set to MANUAL mode.
Step 6 :
Use the foot-switch to release some media on the rear.
Next step on next page
We recommend to wear cotton gloves to avoid fingerprints on the inkjet media.
- 7
)
STEPS
Make sure the core is longer then the media width.
58
Chapter 4 : Preparing for a job
End of the installing the media procedure
AP-75037, Rev. 1.1, 24/04/2006

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cs9090

Table of Contents