Errordisplay Menu; Media Detection Menu - Oce CS9065 User Manual

5.4.5.2 ErrorDisplay menu

To set display method to the operation panel when a minor error occurred.
Current parameter →
Setup items Parameters
ErrorDisplay <Off>
On
-

5.4.5.3 Media detection menu

When media has been initialized, to perform detection of width and edge of the media.
Current parameter →
Setup items Parameters
media detect <Normal>
OFF
Take-up mechanism
RollFeed
-
Notes :
•
•
•
•
•
•
* ErrorDisp. *
F1 → OFF
- OFF -
* Detection *
F1 →
Normal
F3 → TakeupRoll
- Normal -
The default setting is 'Rollfeed' as a result of the standard UW/W 100 with your unit.
When setting "Take-up Mechanism" on the Media Detection menu, the following
limits are applied to the operation of the product.
For initial media, only the media width is detected.
Under normal conditions, media cannot be sent backward.
The media cannot be moved forward or backward from the Origin Setting menu.
The settings in the Media Cut menu are disabled, and the settings are changed to
"Off". Refer to Media cut menu
ON
(1/1)
Description
No ErrorDisplay.
To perform ErrorDisplay.
To shift to the previous menu.
Refer to Utility menu
Off
RollFeed
(1/1)
Description
To perform media detection automatically.
No media detection.
Use this setting if using the winding system and the
media is most right loaded.
Use this setting if using the winding system and the
media is center loaded.
•[CANCEL] key: to shift to the previous menu.
Refer to Utility menu
121
Chapter 5 : Handling the printer
← F2
← F2
← F4
AP-75037, Rev. 1.1, 24/04/2006