Layout Method Menu; Joint Printing Menu; Cutting Position Menu - Oce CS9065 User Manual

5.4.3.20 Layout method menu

To set the layout method for printing data.
Current parameter →
Setup items Parameters
Layout method <Command>
MAX-MIN
-

5.4.3.21 Joint printing menu

To set joint printing.
Current parameter →
Setup items Parameters
Joint <Off>
On
-

5.4.3.22 Cutting position Menu

To set the media cutting position after printing has been finished.
Current parameter →
Setup items Parameters
Cutting position Standard
<Data>
-
* Direct... *
F1 → Command
- Command -
* Joint *
F1 → ON
- OFF -
* CutPos. *
F1 →
Standard
- Data -
MAX-MIN
(1/1)
Description
If there is a page size specification command for the
printing data, the media size is determined from the
region specified by the page size specification
command to position the data.
Regardless origin and page size specification
commands, the media size on which data is collected
is determined by the maximum and minimum values
of the actual data, and the data is located so that the
center of the region is the same as the center of the
media.
To shift to the previous menu.
Refer to Layout setup menu
OFF
(1/1)
Description
Does not perform stitching print.
Performs stitching print
- Shifts to the previous menu.
Refer to Layout setup menu
Data
(1/1)
Description
To cut the media to fit the media width, so that it
meets the regulated size.
To cut the media according to the size of the printing
data.
- Shifts to the previous menu.
Refer to Layout setup menu
113
Chapter 5 : Handling the printer
← F2
← F2
← F2
AP-75037, Rev. 1.1, 24/04/2006