Thickness Menu; Heater Menu - Oce CS9065 User Manual

5.4.2.11 Thickness menu

Sets the media thickness.
Setup items Parameters
Thickness 50µm-<100µm>-1500µm

5.4.2.12 Heater menu

Sets the temperature of the Heater.
Use the [F2] or [F4] key to select the requested temperature for the Heater.
Notes :
•
•
Caution :
•
* Thick *
50 µm – 1500 µm
F2, F4
* Heater (A) *
OFF – 50°C
F2, F4
The default setting for the heater is set to '50°C'.
The function of the heater (A) : Warming the transfer paper before entering the
pressure rollers. The pre-expansion helps to minimize media cockling.
We recommend you to set the pre-heater temperature at 50°C. This to be sure that
transfer paper has already expanded a little before reaching the pressure rollers.
+
100 µm -
→ ENTER
Description
Change media thickness by operating the following
keys.
• [F2] key: to increase the setup value.
• [F4] key: to decrease the setup value.
• [ENTER] key: to confirm the setup value and to shift
to the previous menu.
• [CANCEL] key: to cancel the setup value and to
shift to the previous menu.
Refer to User media menu
+
50°C -
→ ENTER
98
Chapter 5 : Handling the printer
← F2
← F4
← F2
← F4
AP-75037, Rev. 1.1, 24/04/2006