Clean The Glue Cleaning Rollers - Oce VarioPrint 6180 Titan Maintenance Manual

Clean the glue cleaning rollers

Open the doors and covers
Introduction
This procedure is only intended for key operators who received the special maintenance training.
When to do
Certain media may contain substances (for example ink or wax) that pollute the machine. This
pollution can lead to decreased image quality and/or machine damage. Depending on the amount
of substances, you must clean the glue cleaning rollers at a certain interval. Consult your service
technician if you need advise.
Before you begin
Make sure that the machine is switched off.
Required tools
Service key (supplied with the machine)
Socket wrench 10 (supplied with the machine)
Heat-resistant gloves (supplied with the machine)
Offset pads (supplied with the machine)
Large sheets of paper to protect the OPC
Océ Cleaner P (supplied with the machine)
Océ Cleaner K
Océ Cleaner T
CAUTION
Hot area. Use heat-resistant gloves.
Procedure
1. Select the maintenance task from the list of the required and suggested maintenance tasks.
[System] view -> maintenance section -> press the [Start maintenance] button.
2. Press [Start] to start the maintenance wizard.
CAUTION
Make sure that the machine is switched off. Opening the doors too soon can possibly
cause injury.
3. Use socket wrench 10 to loosen the bolt of the front doors (2).
Océ VarioPrint 6000 line
Clean the glue cleaning rollers
Chapter 3 - Maintenance tasks - Level 2 73