Oce CS9065 User Manual page 186

Note :
•
Step 5 : While pressing the cutting blade holder tab, rotate the cutting blade holder lever in the direction
shown in the diagram.
Notes :
•
•
Step 6 : Take out the cutting blade.
Notes :
•
•
•
Replace the cutting blade as quickly as possible. If you leave the carriage at the
cutting blade replacement position, the head may be clogged with ink.
Do not push the cutting blade holder tab strongly or release it suddenly. Doing so
may cause the spring incorporated in the cutting blade holder to fly off.
Do not push in the cutting blade holder. Doing so may cause the cutting blade to
damage the inside of the printer.
1 = Cutting blade holder lever
2 = Cutting blade holder
Do not touch the edge of the cutting blade to avoid injury.
Do not drop the cutting blade or apply it on hard material. Doing so may damage or
break the cutting blade.
Dispose the used cutting blade; put it in a plastic bag in accordance with local
regulations or laws.
186
Chapter 7 : Maintenance
AP-75037, Rev. 1.1, 24/04/2006