4.4 TURNING THE POWER ON/OFF
Caution :
•
4.4.1 Turning the power ON
Turn the power of the unit ON according to following procedure :
Step 1 :
Press the [POWER] key of the operation panel to turn the unit ON.
•
The POWER lamp of the operation panel will light (green).
Step 1 :
The unit will initialize start up operations.
Step 2 :
After finishing initial start up operations, the unit will enter the normal operating condition.
Before powering ON the unit for the first time, make sure to:
Remove the dummy cassettes
Remove the waste tube clamps
Remove the bag enclosing the waste tubes
Connect the waste tubes
46
Chapter 4 : Preparing for a job
End of the power on procedure
AP-75037, Rev. 1.1, 24/04/2006