Head Cleaning - Oce CS9065 User Manual

7.4.3 Head cleaning

If printouts become faint or partially missed, perform head cleaning to clean the surface of the head and the
nozzles.
Follow the 9 steps below to perform head cleaning.
Note :
•
Step 1 : Make sure that the state of the product is normal.
Caution :
•
Step 2 : Perform a nozzle check print.
Refer to 4.7 Testprinting (page 62) for more info about performing a nozzle check print.
Step 3 : Check if the print head, referring to the diagram below.
Step 4 : Check the printer is in the normal status.
Step 5 : Press the [F2] key on the operation panel.
The printer enters the cleaning menu.
Remove media before performing head cleaning.
If you perform head cleaning with media installed, the head may contact the media.
Be sure not to pinch your fingers while opening and closing the front cover.
Ready to print
Heaters
Cut&Feed
User1
Cleaning
ALL
F1, F2 > ENTER
Cleaning
Lever Up
xxxm
Normal
193
Chapter 7 : Maintenance
AP-75037, Rev. 1.1, 24/04/2006