Command Select Menu; Print Step Menu; Print Position Menu - Oce CS9065 User Manual

5.4.3.11 Command select menu

To make the settings for the conditions of printer commands sent from the computer to the printer.
Current parameter →
Setup items Parameters
Command MH-GL, GL2
MH-GL2
<RTL-PASS>
-

5.4.3.12 Print step menu

To set the units for amount of movement for printing.
Current parameter →
Setup items Parameters
Print step <0.010mm>
<0.025mm>
-
Notes :
Please note that some software packages use the "step per mm" terminology, in which
a program step of 0.025 mm corresponds with 40 steps per mm and a program step of
0.010 mm with 100 steps per mm.

5.4.3.13 Print position menu

To set the initial writing position for printing.
Current parameter →
Setup items Parameters
Print position <P1>
LL
Full
-
* Command *
F1 → ML – GL. GL2
F3 → RTL – PASS
- RTL –PASS -
* Step *
F1 → 0.010 mm
- 0.010 mm -
* Position *
F1 →
P1
F3 → Full
- P1 -
ML – GL2
(1/1)
Description
To set to MH-GL, GL2.
To set to MH- GL2.
To set to RTL-PASS.
To shift to the previous menu.
Refer to Command setup menu
0.025 mm
(1/1)
Description
To set the printing units to 0.010mm.
To set the printing units to 0.025mm.
To shift to the previous menu.
Refer to Command setup menu
LL
(1/1)
Description
To set the initial location of the scaling point.
To set the lower left position of the hard clip.
To set the lower left position of the media.
To shift to the previous menu.
Refer to Setup menu
109
Chapter 5 : Handling the printer
← F2
← F2
← F2
AP-75037, Rev. 1.1, 24/04/2006