Adjusting The Position Of The Main Unit To The Stand; Installing The Uw/W - Oce CS9065 User Manual

Hide thumbs Also See for CS9065:
Table of Contents

Advertisement

3.3.3 Adjusting the position of the main unit to the stand

After installation of the main unit onto the stand, please check if there is no gap between the printer body and
the stand.
When you notice that there is a gap between the printer body and the stand, please follow the instructions
mentioned below to minimize this gap.
Notes :
Please find enclosed three types of spacers.
Procedure :
Step 1 :
Decide if the stand spacers are necessary, using the table below.
IF ...
there is a gap between the stand and
the main unit.
there is NO gap between the stand and
the main unit.
Step 2 :
Loosen (don't remove !) the screws fixing the stand to the unit.
Step 3 :
Insert a stand spacer between the stand and the printer body.
Step 4 :
Fully insert the spacer between the stand and the printer body.
Step 5 :
Tighten the screw.

3.3.4 Installing the UW/W 100

Notes :
5 pieces : 0.3 mm spacer
5 pieces : 0.5 mm spacer
5 pieces : 1.0 mm spacer
Please refer to the User's Guide of the UW/W 100 to install it.
Adjusting the weight supports of the UW/W 100 has to be done AFTER placing
the printer on the right place and leveling it.
THEN ...
stand spacers are necessary, continue
with the procedure
stand spacers are not necessary, stop
this procedure
34
Chapter 3 : Setting up the unit
AP-75037, Rev. 1.1, 24/04/2006

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cs9090

Table of Contents