When Media Jams Occur; How To Remove A Piece Of Media (Cut Media) - Oce CS9065 User Manual

6.4 WHEN MEDIA JAMS OCCUR

If the loaded media gets jammed in the printer, follow the steps below to remove the media.

6.4.1 How to remove a piece of media (cut media)

Step 1 : Press [F4] to raise the pressure rollers.
•
The MEDIA SET lamp will turn on (orange).
•
The following message is displayed on the operation panel.
Note :
For raising or lowering the pressure rollers, you can use the foot switch instead
of the operation panel.
Step 2 : If a piece of media or media dust is stocked in the printer, open the front cover and remove the
piece of media or media dust.
Caution :
•
Step 3 : If there is an error requiring a restart, power the printer OFF and ON again.
→ Please Set Paper
Heaters
Cut&Feed
User1
Be sure not to pinch your fingers while opening and closing media cover.
1 = Front Cover
Cleaning
LeverUp
xxxm
172
Chapter 6 : Troubleshooting
End of the procedure
AP-75037, Rev. 1.1, 24/04/2006