Oce CS9065 User Manual page 44

Caution :
•
•
•
Procedure (2 steps) :
Step 1 : Plug the power cable to the AC inlet on the back of the printer.
Step 2 : Plug the cable correctly in the outlet.
Notes :
Note :
•
•
Note :
•
Follow the instructions below when handling the power plug. Otherwise, fire may
occur.
Wipe away dust and any other residue before inserting the plug.
o
Ensure that the plug is firmly inserted as far as it will go.
o
Ensure that the plug has been disconnected from the power socket when it is not
used for a long time.
Earth wires must be connected to wires or terminals that fulfill the conditions :
Earth terminals of power socket
o
Earth wires with copper morsel that is at least 650 mm under ground
o
1 = AC inlet
2 = Power cable
If you cannot use earth terminals or find any of them, contact the shop where you
bought your printer.
Do not unplug the power cable when the printer is on. If the power cable has been
unplugged, leave the printer for at least 1 minute before plugging in the cable.
If the power cable is damaged, contact one of the following :
The distributor where you bought your OCÉ printer.
o
Your local Océ representative.
o
44
Chapter 4 : Preparing for a job
AP-75037, Rev. 1.1, 24/04/2006