Setting Media Type - Oce CS9065 User Manual

4.6.4 Setting media type

The procedure for setting media type is explained below. (4 steps)
Step 1 :
Turn the printer on and load the media.
Once the media has been set, the media initial menu will be displayed.
Step 2 :
Press one of the following keys on the operation panel, and select the current media type.
When alternating roll/sheet media selection: [F2]
When changing from media loading: [F3]
When changing media type: [F4]
1.1.1.1.1 Setup Key
items
Media type F2
Lever Down/Up F3
Media Type F4
Step 3 :
Press the [Enter] key on the operation panel.
The media type has been set.
"Media Initial" is displayed on the LCD, and the printer starts the media initial operation.
Note :
•
Leave the printer for 10 seconds without doing anything
Step 4 :
When the media initial operation finishes, the printer moves to normal status.
The setting media loading procedure has been completed.
* PaperInitialMenu *
F3 → LeverUp
F2, F4 → ENTER or F3
Parameters Description
Roll media Alternates the roll media type.
• Roll media: Set when loading roll media.
Sheet media
• Sheet media: Set when loading sheet media.
Lever up Switches between up and down motion of the pressure rollers.
Use this when starting over from the media setup.
Lever down
User 1 Set media type for printing.
For setup values of printing operation, eight settings of "user 1-
User 2
8" can be set.
User 3
Refer to 5.4 Menu setup on the operation panel (page 88)
User 4
User 5
User 6
User 7
User 8
The printer starts the media initial operation if you :
Press the [CANCEL] key on the operation panel
o
Paper Initial
Ready to print
Heaters
Cut&Feed
User1
Roll
User1
User 1
Cleaning
Lever Up
xxxm
61
Chapter 4 : Preparing for a job
← F2
← F4
End of the setting media procedure
AP-75037, Rev. 1.1, 24/04/2006