Oce CS9065 User Manual page 187

Step 7 : Insert the new cutter into the media cutting blade holder.
Step 8 : While slightly pressing the cutting blade holder tab, return the cutting blade lever to its original
position.
Notes :
•
•
•
Step 9 : Close the front cover.
Step 10 : Press the [ENTER] key on the operation panel.
The carriage returns to its original position and returns to menu 6/7.
The printer returns to the normal status when pressing the [CANCEL] key.
Step 11 : Cutting blade replacement has been finished.
1 = Cutting blade
Do not push the cutting blade holder tab strongly or release it suddenly. Doing so
may cause the spring incorporated in the cutting blade holder to fly off.
Do not push in the cutting blade holder. Doing so may cause the cutting blade to
damage the inside of the printer.
Attach the cutting blade holder lever correctly, referring to the diagram below. If it is
not attached correctly, errors may occur.
If an error occurs, make sure that the cutting blade holder lever is attached correctly.
Ready to print
Heaters
Cut&Feed
User1
Cleaning
Lever Up
xxxm
187
Chapter 7 : Maintenance
End of procedure
AP-75037, Rev. 1.1, 24/04/2006