Command Error Display And Solutions; Error Requiring A Restart - Oce CS9065 User Manual

6.3.4 Command error display and solutions

Following are command error descriptions and possible solutions during printer operations.
Command errors are displayed when an error has occurred while converting the command data sent from
computer to printer.
If a command error occurs, the following error messages are displayed and the printer stops.
Solve the problem to delete the error message and restart the printer.
No. Message
1 command status
MH** Error [ ]
Notes :
•
•
•

6.3.5 Error requiring a restart

Following are descriptions and solutions requiring a restart.
Errors requiring a restart are displayed when the following fatal error has occurred during printer operation.
•
Foreign material disturbing the printer operation is involved in the printer.
•
An electrical circuit (such as board, motor, or sensor) failure has occurred.
•
An error on the control program has occurred.
If error requiring a restart has occurred, the printer prints and then stops (see below).
(1) Power relating to the driving system is shut off automatically.
(2) All indicator lights on the operation panel are turned on and beeps sound continuously.
(3) An error message is displayed on the operation panel.
Press any key on the operation panel to stop the beep sounds.
If an error requiring a restart has occurred, solve the problems to restart the printer and delete the error.
If the same error message is displayed again, contact your local Océ representative. Be sure to inquire the
code numbers of the error messages.
Command Status
MH * * * * Err.
Descriptions
Invalid command data is
sent from computer.
*** in error messages are code numbers indicating what kind of error occurred.
[ ] may indicate the command code of the error.
For the settings on a computer, refer to the computer's operation manual.
System Err
OOOOOOOOO
[ ]
Solution
Make sure that the settings of
the computer and the printer
match.
E * * *
[ ]
170
Chapter 6 : Troubleshooting
Reference
Refer to 'Menu
setup on the
operation panel'
AP-75037, Rev. 1.1, 24/04/2006