Introduction; Connecting The Power Cable - Oce CS9065 User Manual

4.1 INTRODUCTION

The procedures needed before using the printer are explained below.

4.2 CONNECTING THE POWER CABLE

Warnings :
Warning :
•
•
•
Caution :
•
Warning :
•
•
•
•
•
Make sure that the enclosed power cable is used. Use of a different cable
may result in electric shock or fire.
Do not use a damaged power cable. Doing so may result in electric shock or
fire.
The disconnect device is the plug on the power supply cord.
Be careful of the following when handling the power cable.
Do not make any modifications to the power cable.
o
Do not place anything heavy on the power cable.
o
Do not bend, twist, or pull the cable.
o
Do not wire the cable near equipment that generates heat.
o
Do not attempt to plug in electrical plugs with wet hands. Doing so may
result in electrical shock.
Be sure to use the specified voltage (AC 100V-120V/220V-240V). Otherwise,
electrical shock or fire may occur.
Use electricity directly from a power outlet (AC 100V-120V/220V-240V). Do not
put many loads on one electrical output. Otherwise, heat may be generated
and cause fire.
Be sure to use an outlet with an earth terminal, and use the terminal
correctly. Otherwise, electrical shock or fire may occur.
Do not connect earth cables in the following areas :
Gas pipes. Doing so may cause fire or an explosion.
o
Earth terminals for telephone lines or lightning rods. Doing so may
o
cause a large flow of voltage if lightning occurs.
Water pipes or faucets. If there is a plastic part in the pipe, the
o
earthing will not work correctly.
43
Chapter 4 : Preparing for a job
AP-75037, Rev. 1.1, 24/04/2006