Transfer And Transportation; Transferring The Printer - Oce CS9065 User Manual

7.5 TRANSFER AND TRANSPORTATION

This section explains transferring and transporting the printer.

7.5.1 Transferring the printer

Following are instructions for transferring the printer.
Caution :
(1) Before the transfer
If you are using the stand, follow the 5 steps below to transfer the printer.
Step 1 : Make sure the printer is turned off.
Step 2 : Make sure the head is in the right edge position (capping position).
Step 3 : Disconnect the power cable and all other cables.
Step 4 : The four adjusters are turned in the direction shown on the diagram.
Step 5 : Transfer the printer.
Note :
•
•
Keep the printer horizontally during transfer.
•
Do not tilt the printer, stand it against a wall, or turn it upside down. Doing so
may cause ink to leak inside the printer. Also, movement after transport is not
covered by the warranty.
•
Have two or more people to transport the printer.
The caster attached to the stand has been designed for transferring the printer
during short distances.
195
Chapter 8 : Appendix
End of procedure
AP-75037, Rev. 1.1, 24/04/2006