Oce CS9065 User Manual page 163

(10) Ink is not used though you performed initial ink charge.
No. Possible cause
1 The ink cassette is cold or frozen.
2 You turned off the printer during
the initial ink charging.
3 The printer rarely prints correctly
only after initial ink charging.
(11) The media is off or damaged when loading it.
Note :
•
No. Possible cause
1 You did not use recommended
media.
2 The loading position of the media
is not correct.
3 Foreign material, such a piece of
media, is attached to the pressure
rollers.
4 You used the printer in direct
sunlight or other locations not
appropriate for the specified
environment.
5 You loaded sheet media into the
printer.
6 You used folded, creased, or
curled media.
7 Check the media for curling or
liftoff.
Leave the ink cassette in
normal temperature for
three hours at least, and
perform cleaning a few
times.
Turn on the printer to
continue the initial ink
charging.
Perform cleaning a few
times and check again.
Remove the jammed or damaged media, referring to "When media jams
occur".
Use recommended media.
Load the media correctly.
Clean the pressure rollers.
Use the printer in the
specified environment.
Set the CutSize setting to
Length or Width.
Replace with new media.
Use the recommended
media.
When using media other
than recommended
media, set the following
items in the media setting
menu.
• Media
• HeadHeight
• Stiff
Solutions
Solutions
163
Chapter 6 : Troubleshooting
References
Refer to 'Head cleaning'
Refer to 'Installing ink cassettes'
Refer to 'Head cleaning'
References
Refer to 'Media type'
Refer to 'Loading media'
Refer to 'Cleaning the inside of the
printer'
Refer to 'Product Specifications'
Refer to 'Menu setup on the
operation panel'
Refer to 'Cautions on handling
media'
Refer to 'Media type'
Refer to 'Menu setup on the
operation panel'
AP-75037, Rev. 1.1, 24/04/2006