Halftone Menu; Layout Setup Menu - Oce CS9065 User Manual

5.4.3.18 Halftone menu

When creating prints of MH-GL/GL2 (vector) data and RTL-PASS (raster) data that has not been converted
into binary, to set the screening method.
Current parameter →
Setup items Parameters
Halftone <Speed>
Quality
Thin
-

5.4.3.19 Layout setup menu

Makes various settings on layout function.
Notes :
•
•
Setup items Parameters
Layout Direct
Joint
CtPos
-
* Halftone. *
F1 →
Speed
F3 → Thin
- Speed -
The layout function automatically determines the size of printing data sent from the
computer, and then determines the amount of roll media required without wasting
media.
If sheet media has been loaded, the layout function is disabled.
* Layout. *
F1 → Direct.
F3 → CtPos.
Quality
(1/1)
Description
To use the error diffusion matrix to perform rapid
screening.
Screening is performed at high quality according to
the method of minimal average error.
When printing data created for a competitor's printer,
make this setting if the Speed" setting could result in
dark prints.
To shift to the previous menu.
Refer to Command setup menu
Joint
(1/1)
Description
To set the layout method for printing data.
Refer to 'Layout method menu'
Makes settings for stitching print.
Refer to 'Joint printing menu'
To set the media cutting position after printing has
been completed.
Refer to 'Cutting position Menu'
[CANCEL] key: To shift to the previous menu.
Refer to Setup menu
112
Chapter 5 : Handling the printer
← F2
← F2
AP-75037, Rev. 1.1, 24/04/2006