Fujitsu PRIMERGY BX900 User Manual page 310

9.4.7.4 MAC Config
A MAC ACL consists of a set of rules which are matched sequentially against a packet. When a packet
meets the match criteria of a rule, the specified rule action (Permit/Deny) is taken and the additional
rules are not checked for a match. On this menu the interfaces to which an MAC ACL applies must be
specified, as well as whether it applies to inbound or outbound traffic. Rules for the MAC ACL are
specified/created using the MAC ACL Rule Configuration menu.
Figure : Access Control Lists MAC Config
Selection Criteria
MAC ACL - A new MAC Access Control List may be created or the configuration of an existing MAC
ACL can be updated based on selection.
Configurable Data
MAC ACL Name - Specifies MAC ACL Name string which may include alphabetic, numeric, dash,
underscore or space characters only. The name must start with an alphabetic character. This field
displays the name of the currently selected MAC ACL if the ACL has already been created.
Non-Configurable Data
Table - Displays the current and maximum number of MAC ACLs.
Current Size - The current number of MAC ACLs.
Max Size – The maximum number of MAC ACLs.
Command Buttons
Apply - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
Rename - Renames the currently selected MAC ACL.
Delete - Removes the currently selected MAC ACL from the switch configuration.
2011 Fujitsu Technology Solutions
©
308