Fujitsu PRIMERGY BX900 User Manual page 540

10.6.6.3 snmptrap <name> <ipaddr | ipv6Addr>
This command adds an SNMP trap name. The maximum length of the name is 16 case-sensitive
alphanumeric characters.
Syntax
snmptrap <name> <ipaddr | ipv6Addr>
no snmptrap <name> <ipaddr | ipv6Addr>
<name> - SNMP trap name (Range: up to 64 case-sensitive alphanumeric characters).
<ipaddr | ipv6Addr> - an IPv4 or IPv6 address of the trap receiver.
no - This command deletes trap receivers for a community.
Default Setting
None
Command Mode
Global Config
10.6.6.4 snmptrap ipaddr
This command changes the IP address of the trap receiver for the specified community name. The
maximum length of name is 64 case-sensitive alphanumeric characters.
Note: IP or IPv6 addresses in the SNMP trap receiver table must be unique for the same community
name. If you make multiple entries using the same IP address and community name, the first entry is
retained and processed. All duplicate entries are ignored.
Syntax
snmptrap ipaddr <name> <ipaddr | ipv6Addr> <new ipAddr | ipv6Addr>
<name> - SNMP trap name.
<ipaddr | ipv6Addr> - an original IPv4 or IPv6 address.
<new ipAddr | ipv6Addr> - a new IPv4 or IPv6 address.
Default Setting
None
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
538