Boot-System; Classic-View - Fujitsu PRIMERGY BX900 User Manual

10.9.6

boot-system

This command is used to specify the file or image used to start up the system.
Syntax
boot-system {boot-rom | config | opcode | auto-copy-sw} <filename>
boot-system mode {switch | IBP}
<filename> - name of the configuration or image file.
boot-rom - bootrom.
config - configuration file.
opcode - run time operation code.
mode - switch to Switch or IBP.
(*)auto-copy-sw - Configure auto-upgrade function for the stack system.
Note: (*) is the stacking command.
Default Setting
None
Command Mode
Privileged Exec
10.9.7

classic-view

This command is used to change the displayed interface identifier. As the classic-view is enabled, the
reprentation of the interface identifier is changed to <slot/port> format. Use 'no classic-view' to restore to
default UAN display format.
Syntax
classic-view
no classic-view
Default Setting
The displayed interface identifier use the UAN in default.
Command Mode
Privileged Exec
2011 Fujitsu Technology Solutions
©
631