Fujitsu PRIMERGY BX900 User Manual page 782

10.18.2.7 ip access-group
This command attaches a specified access-control list to an interface. The parameter <name> is the name
of the Access Control List.
An optional sequence number may be specified to indicate the order of this IP access list relative to other
IP access lists already assigned to this interface and direction. A lower number indicates higher
precedence order. If a sequence number is already in use for this interface and direction, the specified
access list replaces the currently attached IP access list using that sequence number. If the sequence
number is not specified for this command, a sequence number that is one greater than the highest
sequence number currently in use for this interface and direction is used.
This command specified in 'Interface Config' mode only affects a single interface, whereas the 'Global
Config' mode setting is applied to all interfaces.
Syntax
ip access-group {<1-199> | <name>} in [<1-4294967295>]
no ip access-group {<1-199> | <name>} in
<1-199> The identifier of this ACL.
<name> The identifier of this ACL.
<1-4294967295> The sequence number of this ACL.
no - This command removes a ACL by identifier or name from the interface in a given direction.
Default Setting
None
Command Mode
Global Config, Interface Config
2011 Fujitsu Technology Solutions
©
780