Fujitsu PRIMERGY BX900 User Manual page 315

9.4.7.7 Port Config
Figure : Access Control Lists Port Config
Selection Criteria
Unit/Slot/Port - Specifies list of all available valid interfaces for ACL mapping. All non-routing
physical interfaces and interfaces participating in LAGs are listed.
Direction - Specifies the packet filtering direction for ACL.
Valid Directions
Inbound
ACL Type - Specifies the type of ACL.
Valid ACL Types
IP ACL
MAC ACL
IP ACL - Specifies list of all IP ACLs. This field is visible only if the user has selected "IP ACL" as
"ACL Type".
MAC ACL - Specifies list of all MAC ACLs. This field is visible only if the user has selected "MAC
ACL" as "ACL Type".
Configurable Data
Sequence Number - An optional sequence number may be specified to indicate the order of this
access list relative to other access lists already assigned to this interface and direction. A lower
number indicates higher precedence order. If a sequence number is already in use for this interface
and direction, the specified access list replaces the currently attached access list using that
sequence number. If the sequence number is not specified by the user, a sequence number that is
one greater than the highest sequence number currently in use for this interface and direction will be
used. Valid range is (1 to 4294967295).
Non-Configurable Data
Unit/Slot/Port - Displays selected interface.
Direction - Displays selected packet filtering direction for ACL.
ACL Type - Displays the type of ACL assigned to selected interface and direction.
2011 Fujitsu Technology Solutions
©
313