Configuring The Terminal - Fujitsu PRIMERGY BX900 User Manual

5.4

Configuring the Terminal

To configure the device, the station must be running terminal emulation software. Ensure that Ethernet
Connection Blade Module is correctly mounted and is connected to the chassis serial port. Ensure that
the terminal emulation software is set as follows: Connect to the serial port of PRIMERGY BX900
Management Blade and use console redirection function to get the console access of Ethernet
Connection Blade.
1. Set the data format to 115200 baud rate, 8 data bits, 1 stop bit and no parity.
i
2. Set Flow Control to none.
3. Under Properties, select VT100 for emulation mode.
4. Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that the setting is for
Terminal keys (not Windows keys).
For accessing Ethernet Connection Blade Module from terminal perform following steps:
1. Connect your terminal to the serial port of the Management Blade.
2. Use console redirection function provided on Management Blade to get the access of the desired
Ethernet Connection Blade.
3. Press <Enter> few times to ensure that terminal connection is successful.
2011 Fujitsu Technology Solutions
©
53