Fujitsu PRIMERGY BX900 User Manual page 84

Web Mode - Specify whether the switch may be accessed from a web browser. If you choose to
enable web mode you will be able to manage the switch from a web browser. The factory default is
enabled.
Java Mode - Enable or disable the java applet that displays a picture of the switch at the top right of
the screen. If you run the applet you will be able to click on the picture of the switch to select
configuration screens instead of using the navigation tree at the left side of the screen. The factory
default is enabled.
Configurable Data
IP Address - The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask - The IP subnet mask for the interface. The factory default value is 0.0.0.0.
Default Gateway - The default gateway for the IP interface. The factory default value is 0.0.0.0. You
cannot set default gateway for both the In-Band Mgmt and the Out-of-Band Mgmt at the same time.
You can modify the gateway here if the gateway of Out-of-Band Mgmt is configured to 0.0.0.0.
Management VLAN ID - Specifies the management VLAN ID of the switch. It may be configured to
any value in the range of 1 - 4093. The management VLAN is used for management of the switch.
This field is configurable for administrative users and read-only for other users.
Web Port - This select field is used to set the HTTP Port Number. The value must be in the range of
1 to 65535. Port 80 is the default value. The currently configured value is shown when the web page
is displayed.
Non-Configurable Data
Burned-in MAC Address - The burned-in MAC address used for in-band connectivity if you choose
not to configure a locally administered address. (Only used in non-stackable connection blade)
Operational MAC Address - The operational MAC address of this switch. (Only used in stackable
connection blade)
IPv6 Address - Display IPv6 address.
IPv6 Default Router - Display IPv6 Default Router Address.
Command Buttons
Apply - Update the switch with the values on the screen. If you want the switch to retain the new
values across a power cycle you must perform a save.
2011 Fujitsu Technology Solutions
©
82