Fujitsu PRIMERGY BX900 User Manual page 335

9.5.1.9 Service Config
Figure : Differentiated Services Service Config
Selection Criteria
Unit/Slot/Port - Select the Unit/Slot/Port that uniquely specifies an interface. This is a list of all valid
slot number and port number combinations in the system. For Read/Write users where 'All' appears
in the list, select it to specify all interfaces.
Direction - Select the traffic direction of this service interface. This selection is only available to
Read/Write users when Unit/Slot/Port is specified as 'All'.
Configurable Data
Policy In - This lists all the policy names of type 'In' from which one can be selected. If 'none' is
selected, this will detach the policy from the interface in this direction. This field is not shown for
Read/Write users where inbound service policy attachment is not supported by the platform.
Non-Configurable Data
This information is only displayed when Unit/Slot/Port is specified as 'All'.
Unit/Slot/Port - Shows the Unit/Slot/Port that uniquely specifies an interface.
Direction - Shows that the traffic direction of this service interface is In.
Oper. Status - Shows the operational status of this service interface, either Up or Down.
Policy Name - Shows the name of the attached policy.
Command Buttons
Apply - Send the updated screen to the switch and cause the changes to take effect on the switch
but these changes will not be retained across a power cycle unless a save is performed.
2011 Fujitsu Technology Solutions
©
333