Fujitsu PRIMERGY BX900 User Manual page 70

the provisioned name has been used in the configuration there should be no occurrences of
the previous switch id in the running config.
If not found but there is a provisioned entry for the switch id of the new member it depends on
the provisioned name of this entry. If there is no provisioned name defined the master should
use this provisioned entry for the new member. If there is a provisioned name (which
inevitably doesn't correspond to the UAN of the new member) another switch id should be
elected (see below).
If not found and there is no provisioned entry for the switch id the stack master should act as
before. A new entry in the stack member list is created. For brand-new connection blades
which require a switch id election see below.
6. A new switch id has to be elected for new stack members in the following situations:
The switch id of the new member is occupied by another active member (behavior as
before).
The switch id of the new member is used by a provisioned entry for which a provisioned
name is defined and the provisioned name is not equal to the UAN of the new member.
If the new member is a brand-new connection blade (behavior as before).
The switch id election should associate the lowest id which is either unused or used in a
provisioned entry with NO provision name.
If all switch ids are occupied by either active members or provisioned entries with provisioned
names the lowest switch id of these provisioned entries should be associated. The provisioned
name of the selected entry should be replaced by the UAN of the new member and the
corresponding interface configuration (which is based on the provisioned name of this entry)
should also be transformed to the UAN of the new member.
7. The customer has to take care for unique UANs. Problems resulting from duplicate UANs cannot
be intercepted.
2011 Fujitsu Technology Solutions
©
68