Fujitsu PRIMERGY BX900 User Manual page 134

9.2.8.4 Trap Receiver Config
This menu will display an entry for every active Trap Receiver.
Figure : SNMP Trap Receiver Config
Selection Criteria
Community/User - You can use this screen to reconfigure an existing community or SNMP user, or
to create a new one. Use this pulldown menu to select one of the existing community names or
SNMP user, or select 'Create' to add a new one.
SNMP Version - Select the trap version to be used by the receiver from the pull down menu:
SNMP v1 - Uses SNMP v1 to send traps to the receiver.
SNMP v2 - Uses SNMP v2 to send traps to the receiver.
SNMP v3 - Uses SNMP v3 to send traps to the receiver.
Protocol - Select IPv4 or IPv6 to configure the corresponding attributes.
Security Level - Select the SNMP User's security status from the pulldown menu:
noAuthNoPriv - Authentication Protocol is "None".
authNoPriv - Authentication Protocol is setting and Encryption Protocol is "None".
authPriv - Both Authentication Protocol and Encryption Protocol is setting.
Status - Select the receiver's status from the pull down menu:
Enable - Send traps to the receiver
Disable - Do not send traps to the receiver.
Configurable Data
SNMP Community Name/SNMP User - Enter the community string or SNMP user for the SNMP
trap packet to be sent to the trap manager. This may be up to 16 characters and is case sensitive.
IP Address - Enter the IP address to receive SNMP traps from this device. Enter 4 numbers
between 0 and 255 separated by periods.
2011 Fujitsu Technology Solutions
©
132