Address to the Radius servers. If not mentioned, then the outgoing interface IP address that is used
to send the packet to the Radius server is added as NAS-IP Address.
Radius Attribute 95 (NAS-IPv6 Address) - Select if the Radius Attribute 95 (NAS-IPv6 Address)
inclusion in Radius Requests is enabled or disabled. Mention explicitly the IPv6 address to be sent
as NAS-IPv6 Address to the Radius servers. If not mentioned, then the outgoing interface IPv6
address that is used to send the packet to the Radius server is added as NAS-IPv6 Address.
Non-Configurable Data
Current Server - The IP address or host name of the current server. This field is blank if no servers
are configured.
Number of Configured Servers - - The number of RADIUS servers that have been configured. This
value will be in the range of 0 and 3.
Command Buttons
Apply - Send the updated screen to the switch and cause the changes to take effect on the switch
but these changes will not be retained across a power cycle unless a save is performed.
Refresh - Update the information on the page.
2011 Fujitsu Technology Solutions
©
289