Fujitsu PRIMERGY BX900 User Manual page 136

9.2.8.5 Inform Receiver Config
This menu will display an entry for every active SNMP Inform Receiver.
Figure : Inform Recevier Config
Selection Criteria
Admin Mode - You can use this screen to enable or disable the inform function.
Community/User - You can use this screen to reconfigure an existing community or SNMP user, or
to create a new one. Use this pulldown menu to select one of the existing community names or
SNMP user, or select 'Create' to add a new one.
SNMP Version - Select the inform version to be used by the receiver from the pull down menu:
SNMP v2 - Uses SNMP v2 to send informs to the receiver.
SNMP v3 - Uses SNMP v3 to send informs to the receiver.
Protocol - Select IPv4 or IPv6 to configure the corresponding attributes.
Security Level - Select the SNMP User's security status from the pulldown menu:
noAuthNoPriv - Authentication Protocol is "None".
authNoPriv - Authentication Protocol is setting and Encryption Protocol is "None".
authPriv - Both Authentication Protocol and Encryption Protocol is setting.
Status - Select the receiver's status from the pulldown menu:
Enable - Send informs to the receiver
Disable - Do not send informs to the receiver.
Configurable Data
2011 Fujitsu Technology Solutions
©
134