Fujitsu PRIMERGY BX900 User Manual page 703

10.16.1.9 show radius-servers
This command is used to display items of the configured RADIUS servers.
Syntax
show radius-servers
Default Setting
None
Command Mode
Privileged Exec
Display Message
Host Address: IPv4/IPv6 Address of the configured RADIUS server
Port: The port in use by this server
Type: Primary or secondary
Secret Configured: Yes / No
Message Authenticator: The message authenticator attribute configured for the radius server.
10.16.1.10 show radius
This command is used to display the various RADIUS configuration items for the switch.
Syntax
show radius
Default Setting
None
Command Mode
Privileged Exec
Display Message
Current Server Host Address: Indicates the configured server currently in use for authentication
Number of configured servers: The configured IPv4/IPv6 address of the authentication server
Number of retransmits: The configured value of the maximum number of times a request packet is
retransmitted
Timeout Duration: The configured timeout value, in seconds, for request re-transmissions
RADIUS Accounting Mode: Disable or Enabled
RADIUS Dead Time: The configured restore time when RADIUS server is down.
RADIUS Attribute 4 Mode: Disable or Enable RADIUS NAS-IP attribute.
RADIUS Attribute 4 Value: RADIUS NAS-IP value.
RADIUS Attribute 95 Mode: Disable or Enable RADIUS NAS-IPv6 attribute.
RADIUS Attribute 95 Value: RADIUS NAS-IPv6 value.
2011 Fujitsu Technology Solutions
©
701